News News
News News
In the light box we often hear the word backlight module, then the backlight module in the end what is it? The main components of the light source, light guide plate, backplane, reflective film, diffuser, booster, black and white plastic. As the backlight requirements are getting thinner, so some need to add the aluminum frame. General side of the light-type backlight module placed in the bottom of the light guide plate, the leakage from the bottom of the light reflected back to the light guide plate to prevent light leakage, in order to increase the efficiency of light use: and direct-type backlight module is placed The bottom surface of the light box is affixed to it, and the light beam reflected by the diffuser plate is reflected back from the bottom of the light box back to t...
Datetime: 2017 - 06 - 30
浏览次数:8
With the continuous development of light box industry, a variety of light boxes after another. Fabric light box because of its size restrictions, in the subway, railway stations, airports, shopping malls and other fields are widely used.Fabric Face LED Light Box have a printed textile graphic which is tensioned across the fascia by a silicon edge which is pushed into the aluminum profiles around the sides.This enables the light box to go up to super large format sizes with the additional benefit of an easy graphic change.They are very adaptable and can be made to fit within recesses, around co...
发布时间: 2017 - 05 - 16
浏览次数:8
The first method commonly used office is the most simple and most common installation method: first, take a ceiling, the LED panel lights drive into the next to the ceiling, connect the power cord, and then put the panel lights can The.The second method is to lift, to use the hanging line. First, hang the four bases in the roof fixed to the roof, and then the four hanging screw into the LED panel lights, pull the steel plate to adjust the height of the panel can be.The third is concealed. First with a pen to draw the LED panel light box to change the size of the inner edge, and then use the kn...
发布时间: 2017 - 05 - 15
浏览次数:7
Step 1: use the white table top to mark on your acrylic light panel sheet the corners that need to be notched out. Then spray several thin coats of frosted finish paint over the acrylic. The more layers you apply the better. Only frost one side as well.Step 2: Screw all clamp pieces near the bottom of each wide section. On the two smaller sections (not attached to the legs) slightly stagger the clamps because we need to overlap the LED strips on the small ends. They may be hard to see but if you look closely they are slightly staggered. We only did two clamps per wide board and it is plenty! Y...
发布时间: 2017 - 05 - 12
浏览次数:9
LED lighting is a great way to add accent lighting or color to any room, and LED strip lights are the perfect product for the job. LED strip lights can be used for any type of cove—whether it was built in with your home or a DIY project. There are many different options to choose from. With RGB LED strip lights, you can choose from a ton of dynamic color-changing and single-color models with adjustable brightness and speed control.Single-color and variable color temperature strips are also available and can be used with a compatible controller and remote.1.) Before ordering your LED strip ligh...
发布时间: 2017 - 05 - 11
浏览次数:12
The design of the light guide plate is derived from the liquid crystal display of the notebook, and the laser engraving is carried out on the bottom of the optical grade acrylic sheet. The light guide plate is uniformly illuminated through various light density and different sizes. Then choose the light guide plate when we should pay attention to what?Is the light guide plate thinner the better?With the backlight module of the thin, the thickness of the light guide plate because the demand is getting thinner, the thickness of the light guide plate is generally expressed in mm, but also useful ...
发布时间: 2017 - 05 - 10
浏览次数:16
With the continuous development of LED light boxes, fabric light box because of easy installation, not subject to size restrictions by the market.Fabric box advantages:1.Size is not limited, and now the market is a lot of light boxes are size restrictions, such as the ultra-thin light box, more than two meters is difficult to make, and the advantages of the cloth are not limited by the size of the box, very suitable for custom customers demand.2.Energy-saving environmental protection, a square power consumption in 50w or so, compared to traditional light boxes to save electricity costs.3.For p...
发布时间: 2017 - 05 - 09
浏览次数:5
Many LED magnetic light box are now being supplied into the international market. These long-lasting, energy LED magnetic light boxes are perfect for the modern display, replacing bulb, and tube lighting for the display of point-of-sale.The edge light poster frames offer fantastic illumination and a slim frame profile. LED light box are just 20mm deep. Magnetic frame design, the front panel is opened and closed with magnet, easy to change posters. Because these light box are low voltage the power consumption is a fraction of traditional fluorescent tube powered light boxes. This is the environ...
发布时间: 2017 - 05 - 08
浏览次数:11
Modernizing the home or office with LED panel lights in place of old fluorescent ceilinglights is an easy and fast way to save on energy. Plus, the larger panels will provide abrighter environment and cut back on the time needed for regular maintenance. Here are ofthe practical benefits of installing this light option:Great flexibility in designLED panels lights make it possible to benefit from a point-like light source. This makes itpossible for designers to create a kitchen or office layout that takes full adventure ofthe effects and shapes produced by the lights.High brightnessOne of the ma...
发布时间: 2017 - 05 - 06
浏览次数:4
Lighting has come a long way from the old filament/fluorescent bulbs. These types of bulbs have been used for decades, while all other home or DIY products have improved and advanced Lighting has relied on tried and trusted technology.All that is now changing with the advent of LED lighting. LED can create stunning effects and well lit spaces used correctly, all at a fraction of the cost of filament and fluorescent solutions.The newest way that has hit the market is LED Light Flat panels.These fantastic products come in all shapes and sizes suitable for large commercial properties to small res...
发布时间: 2017 - 05 - 05
浏览次数:9
For the LED light guide plate awareness, many people have been confined to, intelligent lighting, the use of inlays on the ceiling. However, the latest data show that LED in the plant lighting, automotive lighting, acrylic light box, Textile Light Box and other fields will be widely used.Plant lightingData show that plants are growing faster than traditional crops and planted plants, and that the plant is growing faster than traditional crops, which is particularly important for many areas that are not conducive to plant growth. But because the regional problems need LED will be different, whi...
发布时间: 2017 - 05 - 04
浏览次数:12
Copyright ©2005 - 2013 COSUN Technology (Shenzhen) CO.,Ltd . 
Addr:No.2 workshop,No,7 Fuping Middle Road, Longgang District, Shenzhen, China
Tel: 86 0755 2835 1026 / (86) 13925201381 / (86)13410272315
Fax: 86 755 28351016-8002
邮编:330520
  • Your Name:
  • *
  • Company Name:
  • *
  • Address:
  • *
  • Telephone:
  • *
  • Fax:
  • *
  • E-mail:
  • *
  • Post Code:
  • *
  • Consulting Theme:
  • *
  • Description:
  • *
在线留言 FEEDBOOK
Our attention Our attention
  • Mobile phone website
  • The official micro-blog